-250x250.jpg)
Click Image for Gallery
An easy-to-use control cable with breakout board which will allow you to interface your MicroFogger to a switch or microcontroller of your choice such as an Arduino. This can be particularly useful when building costumes and props in order to integrate the MicroFogger into a larger system. The control board components come un-soldered so you’ll need to solder the two headers and optional switch yourself. The 4 pins which are available via this accessory serve the following functions:
-Common ground
-Signal input (to trigger the MicroFogger)
-Charging (to charge the MicroFogger from a power supply)
Only on MicroFogger 4 and earlier:
-Battery voltage of the MicroFogger (allows for power draw of up to 500mA)
Please note that this is an advanced item so any damage caused by improper wiring/soldering will not be covered by our warranty.
Weight - 7 g
Input voltage - 3V to 5V
MicroFogger version - 5th Gen,
Compatibility - All MicroFoggers apart from Original MicroFogger
-Common ground
-Signal input (to trigger the MicroFogger)
-Charging (to charge the MicroFogger from a power supply)
Only on MicroFogger 4 and earlier:
-Battery voltage of the MicroFogger (allows for power draw of up to 500mA)
Please note that this is an advanced item so any damage caused by improper wiring/soldering will not be covered by our warranty.
Weight - 7 g
Input voltage - 3V to 5V
MicroFogger version - 5th Gen,
Compatibility - All MicroFoggers apart from Original MicroFogger
